                 Creative TVCoder LATEST INFORMATION
                 ===================================

This file contains information not available  during the  printing of
the manual.  Please read all the sections before you proceed with any
installation procedure.


1. SOFTWARE INSTALLATION

   The   installation   program,  INSTALL.EXE    will   modify   your
   AUTOEXEC.BAT and CONFIG.SYS files.  Your original  files  will  be
   renamed with extension B~K.


   The program  also  allows  you  to  add  a  command  that runs the
   WINSETUP.EXE  program  to  your  Windows 3.1  WIN.INI  file.  This
   program  (WINSETUP.EXE) automatically  create the Creative TVCoder
   Windows application when you run Windows.


   The procedure for installation is as follows.

   a. Run the program INSTALL.EXE  from DOS prompt.  This program can
      be found on Disk #1.

   b. Select "Begin Installation" and follow  the instructions on the
      screen.

   c. Quit the installation program when it completes successfully.

   d. REBOOT YOUR SYSTEM.

   e. You  may  proceed to test your  TVCoder card with  the  program
      TVTEST.EXE located in the \TVCODER sub-directory.

   f. If you choose to have  the  installation  program  modify  your
      WIN.INI file,  a new group  for the  Creative TVCoder  software
      will  be  created  and icons set up for you.  Otherwise, follow
      the procedures below.

      i.   From the FILE menu in Program Manager, choose RUN.

      ii.  Type  "C:\TVCODER\WINSETUP" and press  ENTER, assuming  you
           have installed Creative TVCoder software onto drive C.

      iii. Follow the instructions on  the  screen  to  complete  the
           installation.


                  ******** END OF README.TXT ********
